Bug #2236
sunstone 3.8 would display a single cpu load value, 4.0/4.2 do not
| Status: | Closed | Start date: | 07/28/2013 | |
|---|---|---|---|---|
| Priority: | Normal | Due date: | ||
| Assignee: | - | % Done: | 0% | |
| Category: | Sunstone | |||
| Target version: | - | |||
| Resolution: | worksforme | Pull request: | ||
| Affected Versions: | OpenNebula 4.2 |
Description
Most of our singleton, persistent vm instances don't use much cpu. I have set CPU=.1 in each of those templates. However, sometimes certain vms are busier. In 3.8, I could go to the vm info pane and see what the actual value was, and then place that back into the template; this would allow for better positioning of the vms.
However, 4.0 and the recently released 4.2 no longer display such a simple, single number. The graph that is displayed in 4.2 is not precise enough to figure this out.
History
#1
Updated by Daniel Molina almost 8 years ago
In OpenNebula 4.2 if you click in the "Capacity" tab of the vm panel info, there is a table with the CPU, VCPU and MEMORY values above the graphs. Is that what are you looking for?
#2
Updated by Daniel Molina almost 8 years ago
- Status changed from Pending to Closed
- Resolution set to worksforme